BoomboxByJr
Designer:
BoomboxByJr
Project Category:
Portable Speakers
Project Level:
Intermediate
Project Time:
8-20 Hours
Project Cost:
$100 – $500
Project Description:
Portable Bluetooth ammo can boombox
4 x hivi 3.5 inch drive crossover at 130hz
2 x dayton audio tweets @ 4000hz
3.5 pearless passive radiators
Sure 25 x 2 amp (speakers)
Sure 15×2 amp (tweets)
Sure Bluetooth module
2x usb charging ports
Design Goals:
Portable and loud
Driver Selection:
HiVi B3N 3″ Part # 297-428
Dayton Audio ND16FA-6 5/8″ Soft Dome Neodymium Tweeter Part # 275-025
Peerless by Tymphany 830878 3-1/2″ Passive Radiator Part # 264-1060
Enclosure Design:
Ammo can
Crossover Design:
Dayton Audio PMPC-5.6 5.6uF 250V Precision Audio Capacitor
Part # 027-234 for tweeters
330uF 100V Electrolytic Non-Polarized Crossover Capacitor
Part # 027-374 for speakers wired in parallel
Conclusion:
Not really a hard project a couples holesaws, drill bits, soldering station and a hot glue some patience and time.
About the Designer:
Hobbyist
Project Parts List:
Vey well done, awesome job. Is there any chance of seeing a diagram of how you wired it up, really like the design. I see the three pots for I guess the volume, bass and treble but the board specified does no have them from what I can see, was there another board? I have several old ammo cans needing this installed, again thanks for sharing!