Portable BT

Portable BT


Designer:
Chris

Project Category:
Portable Speakers

Project Level:
Beginner

Project Time:
8-20 Hours

Project Cost:
$100 – $500

Project Description:
This build was my first attempt at building a speaker box. My previous store bought portable speaker gave out so I decided to make one rather than buy another. It is a ported box that contains a 5” midrange and 1” tweeter that can be powered by rechargeable battery pack or ac adapter.

Design Goals:
Needing a speaker that could be portable my goal was to make a box that was small enough to carry around but would still sound good.

Driver Selection:
The 5 inch midrange subwoofer part 295-426 will cover from 50 to 7,000 hz.
The 0.8 inch tweeter part 292-556 covers 1.2 khz to 22 khz. Both are 8 ohm speakers that handle 50 RMS.

Enclosure Design:
The box was constructed from 3/4 inch MDF and covered with a cherry veneer. It has a 1×4 inch port and a stainless carry handle. Measuring at 9 1/2” W, 12” T, 5 1/2” D weighing about 10-12 lbs. Its braced and polyfilled.

Enclosure Assembly:
Putting together the box was not difficult. After cutting all the dimensions I screwed it together with 1 1/4” pocket hole screws. For the bracing I cut out a circle in the middle of a left over piece of MDF then cut that in half. All seams inside the box were covered with silicone with exception of the back panel for access. Its filled with a couple of hand fulls of polyfil.

Crossover Design:
My crossover point is at 4000 khz.

Conclusion:
I am overall pleased with how it came out. The music is clean with crisp highs. It has moderate bass, about as much as you’d expect from a 5 incher. For a total cost $220 I built my first portable bluetooth speaker that I can take around where ever music is needed to fill a room.

About the Designer:
DIY’r with some woodworking experience.

Project Parts List:

Dayton Audio KAB-250v3 2x50W Class D Audio Amplifier Board with Bluetooth 4.0
Dayton Audio KAB-BE 18650 Battery Extension Board for Bluetooth Amplifier Boards
Dayton Audio KAB-FC Function Cables Package for Bluetooth Amplifier Boards
Dayton Audio DS135-8 5″ Designer Series Woofer Speaker
Visaton DT94-8 0.8″ Polycarbonate Dome Tweeter 8 Ohm
Dayton Audio 4k-HPF-8 High Pass Speaker Crossover 4,000 Hz 12 dB/Octave
Dayton Audio 4k-LPF-8 Low Pass Speaker Crossover 4,000 Hz 12 dB/Octave
18650 2600mAh Li-Ion Flat Top Battery 3-Pack
Speaker Cabinet Port Tube 1″ ID x 4″ L Flared
2.5mm Panel Mount DC Jack

4 Comments

Add yours
  1. 1
    Sean Titmas

    Nice job. I really like the asymmetrical layout of the drivers. And that stainless steel handle is really cool. Is that a repurposed drawer pull?

  2. 2
    Sean Titmas

    Nice job. I really like the asymmetrical layout of the drivers. And that stainless steel handle is pretty cool. Is that a repurposed cabinet door pull?

Leave a Reply to Sean Titmas Cancel reply