Tower Speakers

Tower Speakers


Designer:
Doublsmm

Project Category:
Tower Speakers

Project Level:
Intermediate

Project Time:
8-20 Hours

Project Cost:
$100 – $500

Project Description:
Tower speakers with four woofers to provide great low end response and a planar tweeter to work with the woofers and provide a clean sound.

Design Goals:
My goals for these speakers were something that I would be extremely happy with, something that could do everything and something that would look amazing. I’m happy to say I achieved my goal!

Driver Selection:
Woofer Part # 290-218
Tweeter Part # 275-085

Enclosure Design:
Bass reflex, rear ported

Enclosure Assembly:
18mm MDF, nails and wood glue

Crossover Design:
Dayton Audio XO2W-3.5K 2-Way Speaker Crossover

Conclusion:
In conclusion I couldn’t be happier with the end result, these tower speakers sound amazing! The bass is so good that without a high-pass set you barely even need a subwoofer, they are controlled on all genres of music and look amazing! Overall extremely happy with my end result.

Thanks to 123Toid (youtube) for helping me with the graphs for the crossovers!

About the Designer:
My name is Doublsmm and I run an Australian based youtube channel where I build speakers and make videos surrounding them!

Project Parts List:

Dayton Audio ND140-8 5-1/4″ Aluminum Cone Midbass Driver 8 Ohm
Dayton Audio PT2C-8 Planar Tweeter
Dayton Audio XO2W-3.5K 2-Way Speaker Crossover 3,500 Hz
Precision Port 2″ Flared Speaker Cabinet Port Tube Kit

4 Comments

Add yours
  1. 4
    Antony

    Am inlove with your entire set-up if I want to buy how much is it for the entire set-up and which recieved is the best to run the system.

Leave a Reply to James Zamparelli Cancel reply